How to Set Up the SEMTO ST-FL2 Complete Engine & Key-Start Base Kit | Stirlingkit
November 20, 2026How to Set Up the SEMTO ST-FL2 Complete Engine & Mounting Base Kit
Follow this step-by-step guide to mount your SEMTO ST-FL2 8.6cc twin-cylinder engine onto the Premium Mounting Base using its dedicated hole layout, route wires through the deck and under-base battery bay, plumb the Water Cooling & Fuel System Kit, install the supercharger, and operate the control panel safely.
Front Control Panel Functions (Left to Right)
Key Switch
Main safety key switch on the far left. Turn the key to enable control power, and remove it when done to prevent accidental operation.
Metal Toggle Switch
Switches the ignition and cooling fan circuit on or off cleanly so your auxiliary circuits are ready before cranking.
Push-Button Starter
Momentary start button that cranks the starter motor while held down and releases as soon as the engine starts.
Green Status LED
Illuminates in green when power is active on the console, letting you verify system power at a quick glance.
How to Assemble & Connect (5 Steps)
Mount Components to Dedicated Pre-Drilled Zones
- Place the Premium Mounting Base (30 × 22 × 7 cm) on a flat, stable, heat-resistant workbench.
- Align each part from your Water Cooling & Fuel System Kit and engine setup with its pre-drilled position on the aluminum deck: left-side 4 holes for the anodized metal fuel tank legs, center 4 holes for the transparent acrylic coolant reservoir, and right-side mounting points for the SEMTO ST-FL2 engine, mounting brackets, and rear radiator.
- Secure all parts firmly with the supplied screws and hardware—no extra drilling required.
Install the Supercharger Belt & Intake Hose
- Mount the centrifugal supercharger bracket and loop the drive belt between the crankshaft pulley and supercharger pulley.
- Attach the corrugated intake hose from the supercharger outlet to the carburetor intake and secure connections firmly.
Connect & Bleed the Liquid Cooling Loop
- Connect the silicone water hoses and elbow/straight fittings from the Water Cooling & Fuel System Kit in a closed loop across the engine water jacket / built-in pump, radiator, and transparent expansion reservoir.
- Fill the reservoir and radiator with distilled water or diluted coolant. Gently squeeze the silicone hoses and tilt the base slightly so trapped air bubbles rise out of the water jacket, then top off the reservoir.
Connect the Metal Fuel Tank & Lines
- Connect fuel tubing from the anodized aluminum fuel tank to the carburetor fuel inlet, and keep lines clear of hot engine and exhaust surfaces.
- Use the side sight gauge on the metal fuel tank to verify fuel level before each run.
Route Wires Through the Deck & Hide the 11.1V 3S Battery Underneath
- Route the radiator cooling fan plug, ignition, and starter leads down through the dedicated pass-through holes on the deck into the hollow space beneath the mounting base so wires stay off the tabletop.
- Charge your 2000mAh 11.1V 3S LiPo Battery (T-Plug) ahead of time using a compatible B3 10W 2S–3S LiPo Balance Charger, and tuck the battery neatly inside the concealed under-base battery bay.
- Once all connections are verified, plug in the T-Plug connector, turn the key switch and toggle switch, verify the green LED and fan operation, and press the push-button starter to crank.
Customer FAQ
Recommended Base, Cooling/Fuel & Power Gear
Need Matching Parts, Upgrades, or Replacements?
Browse all SEMTO ST-FL2 engines, cooling & fuel hardware, supercharger parts, and mounting bases in one place.
Shop SEMTO ST-FL2 Parts & Accessories →