confused to know how to install your transmission and gearbox into your Cison engine? It's easy and fast! Follow Johnny Q90‘s video to know how to connect Cison Engine and Gearbox together. . Today, I want to share five tips for installing a new RC transmission in your Cison miniature 4-cylinder engine model.
How Does four-speed dual-clutch transmission Work?
A four-speed dual-clutch transmission (DCT) operates with two clutches, engaging odd gears with one clutch and even gears with another. one for odd gears (1st, 3rd) and another for even gears (2nd, 4th). These clutches are pre-engaged, meaning one is ready to transmit power while the other is disengaged, ready to switch. It pre-selects the next gear for quick shifts, releasing one clutch while engaging the other during gear changes. This setup improves efficiency, acceleration, and fuel efficiency by minimizing power interruption.
five tips for installing a new RC transmission in your Cison miniature 4-cylinder engine model.
Tip 1: Follow the Instructions
- If you're installing a new transmission, it comes with a set of instructions. Read and follow these instructions meticulously. It's crucial for the transmission's longevity and to avoid voiding the warranty.
Tip 2: Flush the Transmission Cooler
- Flush the transmission cooler before installation. Debris from a previous transmission failure can contaminate the fluid and damage the new transmission. Use off-the-shelf aerosol cans connected to the cooler lines to flush in the opposite direction of flow.
Tip 3: Replace the Torque Converter
- When replacing the automatic transmission, also replace the torque converter. The old torque converter may contain contaminated fluid and debris, making it essential to avoid potential issues by replacing it.
Tip 4: Check Torque Converter Fitment
- Before installing the new transmission, ensure the torque converter fits properly. Check that it fits into the crankshaft and that the bolts align with the flex plate. This prevents difficulties during the assembly process.
Tip 5: Fill the Torque Converter with Fluid
- Before installing the torque converter, fill it with new automatic transmission fluid. Never install a torque converter dry, as it can ruin the converter. Apply a bit of fluid around the seal to prevent damage during installation.
After installing the torque converter, ensure it is fully seated inside the transmission. Engage the lockup clutch, the input shaft, and the keyway into the front pump. This step is crucial for the proper functioning of the transmission.
0 comments