
Answer: Hexagon socket head screws.
The four screws of the cylinder head are M2.0*12mm
The ones on the side and the flywheel are all M1.5*10mm
2. Is the piston ring made of metal? Or are they made of rubber?
Does it come with one spare sensor?Is there a total of two sensors, one equipped on the engine and a spare one? Does this engine work with Hit and Miss?
Answer: the piston ring is made of rubber. it comes with 2 sensor. 1 for spare. it's a hit and miss engine.
3.How to start this engine? I'm new to it.
Answer:
Note: The engine has been adjusted throttle regulator and ignition timing switch before shipment. Please don't change it if you are a beginner.
Engine start steps:
A) Prepare 3 AA 1.5v batteries, check the engine wiring, connect the fuel tank tube, connect the battery box,
B) Fill the fuel tank with gasoline (95#). When the filling is completed, make sure that there is no air in the tubing,
C) Rotate clockwise by hand to make the mixed gasoline completely enter.
D) Rotate the flywheel, check if there is spark, the cylinder is in normal compression state, you can start,
4. How to adjust the ignition timing?
A). Check that the piston connecting rod is at the leftmost horizontal position (as shown in Figure 1)
B). Check the closing condition of the ignition switch and brass (Figure 2)
C). When both conditions are met, turn the wheel, check that the connecting rod moves to the leftmost 0.2 seconds, and there is spark, you can start the machine
(Figure 3:Throttle regulator)
D)Ground wire and spark plug wiring (Figure 4)
E) Igniter and battery box (Figure 5)
want to know more discussion on this engine? click.
where to buy this engine? click
Is there any way that you can slow the engine down so it will idle? I did not see any throttle control on there I understand about the air mixture believe me.I await your reply. That I have stated before I am very interested in buying it I just have a few questions. Loyd
I don’t think it is a throttle control. It is more likely that it is a mixture control. The fuel/air mix needs to be right for it to run properly.
Tell me why a throttle control on both those is there not hit and miss engines from what you were showing in your little diagram movie there is no throttle on them they constantly run at one high speed that’s not exactly true. Is it? I am still very interested in purchasing them but I’m still looking at I’d like to have them all but right at this particular time I can’t afford it if you know what I’m saying. Well take care my friend and May God bless each and every one of you. I patiently wait your reply. Loyd Kampf
All good information to have. THANKS for the details on this engine.