Stirlingkit User Guide

buy accessories of this v twin engine. click Important: Before starting, please check whether the CDI is normally powered on, turn on the switch, and then rotate the flywheel to observe whether there is a high-voltage spark at the top of the spark plug. If there is no high-voltage spark....

Dear Customer,Most items in Stirlingkit.com have paper instruction manual. Only a few of them have online instruction. when you receive your parcel, please check if there is a USB flash drive there, where the instructions is inserted into the USB. If it's missing or not working, you can also find...

If the engine is difficult to ignite, it may be that the camshaft angle is too small, and the exhaust gas will ignite if it is delayed a little bit, and the exhaust gas will easily be injected back in advance. 1. All the wire must be connected in order...

Latest upgrade: click here this is the most common question asked by our customers.Q1: Is there oil lubrication to the overhead cams or still grease only?A1: The camshaft is circulated by an oil pump and is lubricated by oil.Q2: Conrod big ends are they bronze bushed?A2: yes. With copper sleeve.Q3:...

Q: I recently  bought a C.D.I conversion kit for my Toyan FS- S100A to convert it from methanol to gasoline but it came without any fitting instructions and after spending a great deal of time examining it I can't figure out how to fit the hall sensor bracket to the...

If you want to convert a methanol engine into a gasoline engine, all you need to do is to remove the original flywheel, and then install the flywheel with magnets.and you also need to buy and replace the CDI Hall sensor igniter kit, spark plugs, and gasoline fuel yourself. After you have made it, add gasoline fuel and start your engine to check if it works.