Stirlingkit User Guide

Account

Stirlingkit's Blogs

How to Start and Modify Toyan FS-L400 into the RC Car?

danna Posted on May 17 2021

Stirlingkit team has invited some youtubers to test FS-L400. you can check the videos below to know more about this engine. some of them are from our customers review. if you have something new, please send your youtube video to me. so i can update it in this blog. so...

How to Convert Toyan FS100 Methanol Engine to Gasoline Engine? Stirlingkit

danna Posted on May 08 2021

If you want to convert a methanol engine into a gasoline engine, all you need to do is to remove the original flywheel, and then install the flywheel with magnets.and you also need to buy and replace the CDI Hall sensor igniter kit, spark plugs, and gasoline fuel yourself. After you have made it, add gasoline fuel and start your engine to check if it works.

How do you Build & Debuge a Stirling Engine Step by Step? Stirlingkit

danna Posted on April 21 2021

How To Install and Debuge Stirling Engine? https://www.stirlingkit.com/products/stirling-engine-model-kit-generator-heat-engine-diy-assembly-model-set?_pos=1&_sid=5d4919e6f&_ss=rthere are three key factors for Stirling engine model debugging, one is resistance, the other is air tightness, and the other is heating temperature. to avoid resistance, please follow 4 steps below step by step. Firstly, when installing the flywheel and the small pulley,...

How To Start M16 1.6cc Mini Vertical 4 Stroke Gasoline Engine Model ? Stirlingkit

danna Posted on March 13 2021

M16 Mini Engine & Lombard Linn Halftrack Truck - Project Part 1

The 9 Most Important Things You Need To Know About Toyan FS-L400

danna Posted on February 16 2021

Important Notice: (Please read it before you start to build this engine) Where to Buy Toyan FS-L400 all Accessories: https://www.stirlingkit.com/collections/toyan-fs-l400-engine-parts 1. Piston Rings: Our team has assembled the piston rings in the cylinder liner in advance because it's very difficult to do it for the average people. pls follow the...